• Locate a mortar joint at least 150mm above external ground level. For internal walls, insert the cream in a mortar joint as close to the internal floor level as can be achieved.
• Drill 12mm diameter holes horizontally in the mortar bed to a depth of 10mm less than the wall thickness at centres no greater than 100mm.
• Remove all the dust from the holes. 
• If walls are dry or mildly damp, spray water into the holes until absorbed by mortar. This is a very important step as it increases the effectiveness of the product.
• Fit DPC cartridge with nozzle supplied.
• Inject the DPC cream slowly into each hole using a standard 400ml caulking gun.
• Extend the nozzle of the gun to the rear of the hole and slowly withdraw the nozzle as the cream fills the hole.
• Holes in external walls can be easily capped with SkilledBuild Injection Plugs or alternatively use silicone, resin or mortar.
• Internal holes should be plugged or plastered over using a suitable rennovation plaster, or by simply covering with a skirting board.

This is only a short overview on how to use the product and does not cover all the necessary points. Therefore, please click the 'Product Information Sheet' link below for more information.

• SkilledBuild DampOut+  DPC injection cream does not have a hazard classification and is therefore a low risk product.
• Silicone emulsion formulations may cause mild irritation, therefore, wear lightweight impermeable gloves when handling. 
• Wash splashes from skin and eyes immediately.
• Wash hands and exposed skin before meals and after use.
• Keep out of reach of children.
• Keep in original container in a safe place.

Standard delivery rates and times apply for this product.