DAMP PROOFING CREAM 400ml
Advanced Siloxane Based Chemical Damp Proofing Cream 400ml
Dampout + Damp Proofing Cream your DIY Solution to Rising Damp!
DampOut+ Damp Proofing Cream is an advanced chemical injection cream used to remedy Rising Damp.
Installation of this Damp Proofing Cream is simple and does not require specialist skills or equipment. Installation requires drilling of 12mm holes along a mortar joint, followed by the injection of the Damp Proofing Cream into the holes using a caulking injection gun. Where the Damp Proofing Cream is injected into external walls, the holes can be capped using Damp Proofing Cream Injection Plugs, for a neat finish.
For detailed instructions on installation, see our How To Install Damp Proofing Cream guide.
Our Damp Proofing Cream is a non hazardous product and its performance has been proven in independent tests and research reports.
Size: 400ml Damp Proofing Cream Cartridge.
Shelf Life: Up to 12 months if stored correctly in unopened container.
Most Suited For:
- Damp / wet brick walls.
- Damp / wet masonry walls.
- Damp / wet stone walls.
- Damp/ wet concrete walls.
- Internal and external walls.
- Standard Caulking Gun for 400ml Damp Proofing Cream cartridges.
Recommended H&S Products:
- Safety glasses / goggles.
- Dust Mask (for drilling)
- Ear Defenders (for drilling)
How does Dampout+ Damp Proofing Cream work?
How to damp proof Walls...
For a detailed description on how to use our damp proof cream click here
Locate a mortar joint at least 150mm above external ground level. (For internal walls, insert the damp proof cream in a mortar joint as close to the internal floor level as can be achieved).
Drill 12mm diameter holes horizontally in the mortar bed to a depth of 10mm less than the wall thickness at centres no greater than 100mm.
Remove all the dust from the holes.
If walls are dry or mildly damp, spray water into the holes until absorbed by mortar. This is a very important step as it increases the effectiveness of the product.
Fit Damp Proof Cream cartridge with nozzle supplied.
Inject the Damp Proof Cream cream slowly into each hole using a standard 400ml caulking gun.
Extend the nozzle of the gun to the rear of the hole and slowly withdraw the nozzle as the cream fills the hole.
Holes in external walls can be easily capped with SkilledBuild Injection Plugs or alternatively use silicone, resin or mortar.
Internal holes should be plugged or plastered over using a suitable rennovation plaster, or by simply covering with a skirting board.
Note that cavity walls will require an application to both the inner and external walls.
This is only a short overview on how to use the product and does not cover all the necessary points. Therefore, please click the 'Product Information Sheet' link below for more information.
SkilledBuild DampOut+ Damp Proof Cream does not have a hazard classification and is therefore a low risk product.
Silicone emulsion formulations may cause mild irritation, therefore, wear lightweight impermeable gloves when handling.
Wash splashes from skin and eyes immediately.
Wash hands and exposed skin before meals and after use.
Keep out of reach of children.
Keep in original container in a safe place.
Standard delivery rates and times apply for this product.
Delivery is free if you are a member and the order is over £150.
If you need it really quickly - we can ship in next day UPS for £15.00.